Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999SUBURBAN C2500, 6.5 FREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESCOMPUTER RELEARN PROCEDURES - CARSCAVALIER & SUNFIREPASSWORD LEARN PROCEDURE FOR ANTI-THEFT SYSTEM
1999 Chevrolet Suburban C2500, 6.5 F
Password Learn Procedure For Anti-Theft System
1999 Chevrolet Suburban C2500, 6.5 FSECTION Password Learn Procedure For Anti-Theft System
- Password learn procedure must be performed if Instrument Panel Cluster (IPC) is replaced. A password is communicated between IPC and Powertrain Control Module (PCM) to provide engine operation. If IPC is replaced, the PCM must learn the password from the IPC.
- Attempt to start engine and then leave ignition on. DO NOT turn ignition off. The THEFT SYSTEM indicator light will flash for 10 minutes.NOTE: If PCM is replaced, the Electronically Erasable Programmable Read Only Memory (EEPROM) should be programmed. When EEPROM is programmed, the PCM will learn the password when ignition is initially turned on. Password learn procedure is not required when replacing the PCM and EEPROM is programmed.
- On Cavalier, THEFT SYSTEM indicator light is located on IPC, just above the vehicle mileage indicator. On Sunfire, THEFT SYSTEM indicator light is located on IPC, just above the temperature gauge.
- On all models, once THEFT SYSTEM indicator light stops flashing, attempt to start the engine. If engine starts, the password learn procedure is complete. If engine does not start, ensure procedure was properly followed. If procedure was properly followed, check for any DTCs. If any DTCs exist, perform test procedures for specified DTC and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.