Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999METRO LSI, 4D SEDAN, AUTOMATICLABOR TIMESOTHER VARIANTTRANSMISSIONMANUAL TRANSTRANSAXLE ASSEMBLYREMOVAL & INSTALLATION
1999 Chevrolet Metro LSi, 4D Sedan, Automatic
Removal & Installation
1999 Chevrolet Metro LSi, 4D Sedan, AutomaticSECTION Removal & Installation
WARNING: This page is about the Metro Base, 2D Hatchback, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 1.0L Eng | 4.5 | C | ||
| Combination Procedure: CLUTCH HOUSING CASE: Replace: | ||||
| 1.9 | 1.9 | B | ||
| Combination Procedure: CLUTCH PRESSURE PLATE: Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: CLUTCH RELEASE BEARING: Remove & Replace: | ||||
| 0.2 | C | |||
| Combination Procedure: DIFFERENTIAL ASSEMBLY: Overhaul: | ||||
| 2.5 | A | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.7 | C | |||
| Combination Procedure: INPUT SHAFT: Replace: | ||||
| 1.9 | A | |||
| Combination Procedure: INPUT SHAFT SEAL: Remove & Replace: | ||||
| 1.5 | 1.5 | B | ||
| Combination Procedure: OUTPUT SHAFT: Replace: | ||||
| 2.0 | 2.0 | B | ||
| Combination Procedure: TRANSAXLE ASSEMBLY: Replace: | ||||
| 0.4 | C | |||
| Combination Procedure: TRANSAXLE CASE: Replace: | ||||
| Half | 1.7 | 1.7 | A | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.