Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
This test functions on the assumption that a sudden decrease in non-drive wheel speed must be caused by a brake application. Non-drive wheel speed and stop light switch status are supplied to the PCM through the serial data from the EBTCM. If there is a 2.5 MPH or greater decrease of non-drive wheel speed in.2 second and a transition of the TCC or extended travel contacts of the TCC brake switch occurs without a transition of the stop light switch, DTC will set.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.