Test E: Right Front & Side Doors Unlock From Door Lock Switches, But Not From Remote Control Door Lock Receiver

1999 Chevrolet Cutaway 7.4 JSECTION Test E: Right Front & Side Doors Unlock From Door Lock Switches, But Not From Remote Control Door Lock Receiver
  1. Disconnect remote control door lock receiver connector C1. Remove power door lock relay, located behind right kick panel. Connect self-powered test light between power door lock relay terminal "B" (Tan wire) and remote control door lock receiver connector, terminal "H" (Tan wire).
  2. If test light illuminates, replace remote control door lock receiver. Reprogram replacement remote control door lock receiver to transmitter(s). See RESYNCHRONIZATIONΒ  under PROGRAMMING. If test light does not illuminate, repair open circuit in Tan wire between remote control door lock receiver and splice S243.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.