Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999CORVETTE 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGSTEERING COLUMNSTEERING WHEEL AND STEERING COLUMN - STANDARDADJUSTMENTSDIMMER SWITCH
1999 Chevrolet Corvette 2D Coupe, Standard
Dimmer Switch
1999 Chevrolet Corvette 2D Coupe, StandardSECTION Dimmer Switch
- With switch removed from column bracket, insert a 3/32" drill bit into adjusting pin hole to limit switch travel. See Fig 1. Insert actuator rod into switch. Install switch to column bracket, finger-tighten screws.
- Lightly push switch upward against actuator rod until no lash (free-play) exists between rod and switch. Tighten mounting screws to 35 INCH lbs. (4 N.m). Remove drill bit. Ensure proper switch operation using dimmer/headlight switch handle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.