Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999CORVETTE 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESCOMPUTER RELEARN PROCEDURES - CARSSATURNVEHICLE DRIVEABILITY COMPUTER RELEARN PROCEDURE
1999 Chevrolet Corvette 2D Coupe, Standard
Vehicle Driveability Computer Relearn Procedure
1999 Chevrolet Corvette 2D Coupe, StandardSECTION Vehicle Driveability Computer Relearn Procedure
- If vehicle battery was disconnected or Powertrain Control Module (PCM) was replaced, driving the vehicle will enable the PCM to perform a computer relearn procedure for obtaining proper driveability and engine idle. Until PCM has completed computer relearn procedure, driveability or idle may differ from standard vehicle operation. On A/T models, transaxle shift qualities must be relearned.
- On all models, start engine and warm engine to normal operating temperature. Perform 10 sets of upshifts (1-2, 2-3 and 3-4) at about 30 percent throttle.
- On DOHC engine, while coasting at 35 MPH, slowly accelerate to 1/2 throttle to achieve a 4-3 downshift. Place gearshift in "D3" while coasting at 20 MPH, slowly accelerate at 3/4 throttle to achieve a 3-2 downshift.
- Repeat step 3) 5 times. Vehicle driveability computer relearn procedure is now complete.
- On SOHC engine, while coasting at 40 MPH, slowly accelerate to 1/2 throttle to achieve a 4-3 downshift. Place gearshift in "D3" while coasting at 30 MPH, slowly accelerate at 1/2 throttle to achieve a 3-2 downshift.
- Repeat step 5) 5 times. Vehicle driveability computer relearn procedure is now complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.