Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET1999CORVETTE 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESPECIFICATIONSENGINE CONTROL SYSTEM - SERVICE & ADJUSTMENT SPECIFICATIONSMECHANICAL CHECKSENGINE COMPRESSION

1999 Chevrolet Corvette 2D Coupe, Standard

Engine Compression

1999 Chevrolet Corvette 2D Coupe, StandardSECTION Engine Compression

Check engine compression with engine at normal operating temperature, all spark plugs removed and throttle wide open.

COMPRESSION SPECIFICATIONS

Application

Specification

Normal Compression Pressure

1.0L

199 psi (14.0 kg/cm² )

1.3L

192 psi (13.5 kg/cm² )

1.8L

218 psi (15.3 kg/cm² )

1.9L

185-205 psi (13.0-14.4 kg/cm² )

2.2L, 2.4L, 3.0L, 3.1L, 3.4L, 3.8L, 4.0L, 4.6L & 5.7L

⁽¹⁾

3.5L

⁽²⁾

Minimum Compression Pressure

1.0L & 1.3L

156 psi (11.0 kg/cm² )

1.8L

145 psi (10.2 kg/cm² )

1.9L

180 psi (12.7 kg/cm² )

2.2L, 2.4L, 3.0L, 3.1L, 3.4L, 3.8L, 4.0L, 4.6L & 5.7L

⁽¹⁾

3.5L

⁽²⁾

⁽¹⁾	Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 100 psi (7.0 kg/cm² ).

⁽²⁾	Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 140 psi (9.8 kg/cm² ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.