Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999CHEVY EXPRESS G1500, VAN CARGO, 5.7 RREPAIR AND DIAGNOSISBODY & FRAMEMIRRORSPOWER MIRROR SYSTEMSYSTEM TESTSASTRO & SAFARILEFT-SIDE POWER MIRROR INOPERATIVE IN LEFT/RIGHT POSITIONS
1999 Chevrolet Chevy Express G1500, Van Cargo, 5.7 R
Left-Side Power Mirror Inoperative In Left/Right Positions
1999 Chevrolet Chevy Express G1500, Van Cargo, 5.7 RSECTION Left-Side Power Mirror Inoperative In Left/Right Positions
- Disconnect left-side power mirror harness connector. Connect test light between left-side power mirror harness connector terminal "E" (Light Blue wire) and ground. See Figure . Move power mirror switch to left mirror, LEFT position. If test light illuminates, replace left-side power mirror. See POWER MIRROR ASSEMBLY under REMOVAL & INSTALLATION. If test light does not illuminate, go to next step.
- Using a test light connected to ground, backprobe power mirror switch harness connector terminal "B" (Light Blue wire). See Figure . Move power mirror switch to LEFT position. If test light does not illuminate, replace power mirror switch. If test light illuminates, repair open in Light Blue wire between left-side power mirror connector terminal "E" and power mirror switch connector terminal "B". See WIRING DIAGRAMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.