Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
PCM tests the EVAP system for large and small leaks, excess vacuum, purge flow during non-commanded conditions, fuel level and fuel pressure sensor faults, and EVAP purge and vent valve faults.
PCM monitors the fuel tank pressure sensor in order to determine the level of vacuum/pressure in EVAP system. PCM commands both EVAP purge solenoid and EVAP vent valve on when conditions for running this DTC are met in order to apply engine vacuum to EVAP system.
PCM commands EVAP purge solenoid off once system has reached a predetermined level of vacuum. This test checks if vacuum can be achieved in EVAP system. Failure to develop a vacuum may be caused by a large leak or restriction. This DTC sets after twice failing this test. DTC will set when EVAP cannot develop a vacuum greater than a predetermined value.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.