Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation (3T40 Transaxle)
Disconnect negative battery cable. Raise and support vehicle. Remove right front wheel assembly (if necessary). Disconnect VSS harness connector. Remove VSS housing cover bolts, cover and gasket. Remove spring washer, washers, magnet, coil assembly and "O" ring together as an assembly. To install, reverse removal procedure. Tighten bolt to 97 INCH lbs. (11 N.m).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.