Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1999CAMARO BASE, 2D COUPE, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOW SYSTEMSYMPTOM TESTSTEST 1: ALL WINDOWS INOPERATIVE
1999 Chevrolet Camaro Base, 2D Coupe, Automatic
Test 1: All Windows Inoperative
1999 Chevrolet Camaro Base, 2D Coupe, AutomaticSECTION Test 1: All Windows Inoperative
- Ensure no Body Control Module (BCM) Diagnostic Trouble Codes (DTCs) are stored. See appropriate BODY CONTROL MODULES article. Repair as necessary. If no DTCs exist, go to next step.
- Turn ignition switch to RUN position. Using a test light, backprobe between ground and master switch assembly connector terminal "F" (Brown wire). If test light illuminates, go to step 4 . If test light does not illuminate, go to next step.
- If connection is okay, repair open in Brown wire between power window circuit breaker (30-amp) and master switch assembly connector terminal "F". See WIRING DIAGRAMS .
- Connect a test light between master switch assembly connector terminals "F" (Brown wire) and "A" (Black wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 6 .
- Check for poor connection at master switch assembly. If connection is okay, replace master switch assembly. See WINDOW SWITCH under REMOVAL & INSTALLATION.
- Repair open in Black wire between master switch assembly and ground. See WIRING DIAGRAMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.