SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998TRACKER 4D UTILITY, RWDREPAIR AND DIAGNOSISSUSPENSIONWHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURESTORQUE SPECIFICATIONS
1998 Chevrolet Tracker 4D Utility, RWD

Torque Specifications

1998 Chevrolet Tracker 4D Utility, RWDSECTION Torque Specifications
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
"C" & "K" Series
Tie Rod Adjustment Sleeve Clamp Bolt 14 (19)
Tie Rod Jam Nut 50 (68)
Upper Control Arm Nut(1) 140 (190)
Wheel Lug Nut
5, 6 & 8-Stud Single & Dual Wheels 125 (170)
10-Stud Dual Wheels (C3500HD) 162 (220)
"G" Series
Tie Rod Adjustment Sleeve Clamp Bolt 18 (25)
Upper Control Arm Nut 140 (190)
Wheel Lug Nut 140 (190)
"L" & "M" Series
Cam Bolt Nut 81 (110)
Tie Rod Adjustment Sleeve Clamp Bolt 18 (25)
Wheel Lug Nut 140 (190)
"P" Series
Tie Rod Adjustment Sleeve Clamp Bolt 18 (25)
Upper Control Arm-To-Frame Nut(2) 140 (190)
Wheel Lug Nut
8-Stud Wheels
With Single Front & Rear Wheels 118 (160)
With Single Front & Dual Rear Wheels 140 (190)
10-Stud Wheels
Step 1 140 (190)
Step 2 175 (237)
"S" & "T" Series
Tie Rod Adjustment Sleeve Clamp Bolt
1998 16 (21)
1999 18 (25)
Upper Control Arm Nut
2WD 55 (75)
4WD 85 (115)
Wheel Lug Nut 103 (140)
Tracker
Tie Rod Lock Nuts 48 (65)
Wheel Lug Nut 69 (95)
"U" Series
Strut-To-Knuckle Bolt 91 (123)
Tie Rod Lock Nut 50 (68)
Wheel Lug Nut 103 (140)
(1) Requires Adjustment Kit (J-38794).
(2) Except vehicles with "I" beam front suspension.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.