SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998TRACKER 4D UTILITY, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALENGINE MECHANICAL - 1.6L 4-CYLINDERENGINE OILINGOIL PUMPREASSEMBLY & INSTALLATION
1998 Chevrolet Tracker 4D Utility, RWD

Reassembly & Installation

1998 Chevrolet Tracker 4D Utility, RWDSECTION Reassembly & Installation
  1. To reassemble, reverse disassembly procedure. Coat components with engine oil before installation. Tighten oil pump cover bolts to specification. See TORQUE SPECIFICATIONS  table. Ensure rotors rotate freely by hand after oil pump cover is installed.
  2. To install, reverse removal procedure. Ensure oil pump pins are installed in cylinder block before installing oil pump. Install Oil Seal Guide (J-34853) on crankshaft to prevent damage to oil seal during oil pump installation. See Fig 1.
  3. Make sure all bolts are installed in their proper locations. See Fig 2. Tighten retaining bolts to specification. See TORQUE SPECIFICATIONS  table. Cut oil pump gasket even with cylinder block.
  4. To install remaining components, reverse removal procedure. Use NEW "O" ring on dipstick tube. Use NEW seal on oil pump pick-up tube.
Fig 1: Installing Oil Pump
G90G08909Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.