SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998TRACKER 2D UTILITY, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION DIAGNOSIS & OVERHAUL - 3L30PERFORMANCE TESTSROAD TEST
1998 Chevrolet Tracker 2D Utility, RWD, Automatic

Road Test

1998 Chevrolet Tracker 2D Utility, RWD, AutomaticSECTION Road Test
  1. Ensure vehicle is at operating temperature. Shift transmission into drive. Accelerate vehicle and ensure vehicle upshifts from 1st to 2nd, then to 3rd gear. TCC should apply while in 3rd gear.
    NOTE: TCC will not apply if coolant temperature is below 130°F (54°C).
  2. Depress accelerator pedal to 1/2 position. TCC should release, then transmission should downshift to 2nd gear. Accelerate to cruising speed until TCC is applied. Using left foot, very lightly apply brake pedal. TCC should disengage.
  3. Release accelerator pedal. As vehicle is slowing down, manually shift into 2nd gear, then into low position. Ensure transmission shifts into lower gears and engine braking occurs. Stop vehicle and shift into reverse. Lightly accelerate vehicle to confirm reverse operation. Stop vehicle on slight incline. Shift vehicle into park. Ensure vehicle does not move.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.