Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (ENGINE CONTROLS - TESTS W/CODES - 5.7L)DIAGNOSTIC TROUBLE CODESDTC P1380 - ELECTRONIC BRAKE CONTROL MODULE (EBCM) DTC DETECTED ROUGH ROAD DATA UNSTABLEDIAGNOSTIC PROCEDURES
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Diagnostic Procedures
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Diagnostic Procedures
WARNING: This page is about a different variant/trim than selected.
- Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
- Turn ignition off. Disconnect VCM and EBCM harness connectors. Using DVOM, check for open in serial data circuit between VCM and EBCM. If a problem is found, go to next step. If no problem is found, see ANTI-LOCK BRAKE SYSTEM article in BRAKES section.
- Repair as necessary. After repairs, go to next step.
- Using scan tool, select DTC, CLEAR INFO. Start and warm engine to normal operating temperature. Select DTC, SPECIFIC, then enter this DTC. Operate vehicle within the conditions for setting this DTC. If scan tool indicates that this test ran and passed, go to next step. If scan tool does not indicate that this test ran and passed, DTC is intermittent.
- Using scan tool, select CAPTURE INFO, REVIEW INFO. If any undiagnosed DTCs are displayed, go to applicable DTC test.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.