Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
VCM controls idle speed with an Idle Air Control (IAC) valve to a calculated desired RPM based on sensor inputs and actual engine RPM. VCM uses 4 circuits to move an IAC valve, allowing varying amounts of airflow into intake manifold.
To increase idle RPM, VCM moves IAC valve out, allowing more air to by-pass throttle plate. To decrease RPM, VCM moves IAC valve in, reducing amount of air by-passing throttle plate. Scan tool reads VCM commands to IAC valve in counts. The higher the counts, the more air that is allowed to by-pass throttle plate (higher idle). The lower the counts, less air is allowed to by-pass throttle plates (lower idle).
Conditions for setting DTC:
- No ECT, MAP, TP or VS sensor DTCs are set.
- ECT greater than 122°F (50°C).
- IAT greater than -13°F (-25°C).
- BARO greater than 70 kPa (10,300 ft.).
- Vehicle speed less than 2 MPH.
- System voltage 10-16 volts.
- Engine run time greater than 30 seconds.
- TP less than one percent.
- Conditions are met for greater than 3 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.