Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 907 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSCONSOLE REPLACEMENTINSTALLATION PROCEDURE

1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Console Screws

Courtesy of GENERAL MOTORS CORP.

Position the console on top of the center floor console.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the console screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 2: View Of Auxiliary Power Outlet Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the auxiliary power outlet.
Reposition the center console.

Fig 3: Removing/Installing Cup Holder Liner

Courtesy of GENERAL MOTORS CORP.

Install the cup holder screw.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the cup holder liner.

Fig 4: Locating Console Screws

Courtesy of GENERAL MOTORS CORP.

Reach under the front seats to access the lower console screws.
Install the center console screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Position the front seat forward to the original position.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.