SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 887 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Removal Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the headliner. Refer to HEADLINER REPLACEMENT .
  2. Remove the right I/P insulator. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT -- RIGHT .
  3. Remove the right front carpet retainer. Refer to CARPET RETAINER REPLACEMENT - FRONT .
  4. Pull back the carpet for access.
  5. Disconnect the I/P antenna extension cable from the antenna cable.
    Fig 1: Disconnecting I/P Antenna Extension Cable From Antenna Cable
    G01616303Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the antenna cable from the rear window.
  7. Remove the screw from the antenna extension cable bracket.

    Important:  Take note of the antenna cable routing before removal from the vehicle.

  8. Remove the tape from the antenna cable.
  9. Remove the antenna cable.
    Fig 2: Antenna Extension Cable Bracket & Screw
    G01616304Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.