Removal Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the garnish molding from the right windshield pillar. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR in Interior Trim.
  2. Starting at the right side, carefully lift upwards on the instrument panel (IP) upper trim panel in order to release the retainers from the IP upper trim pad. Work towards the left in order to access the daytime running lamp (DRL) ambient light sensor (1).
    Fig 1: Accessing Daytime Running Lamp Ambient Light Sensor
    G01587066Courtesy of GENERAL MOTORS CORP.
  3. Remove the DRL ambient light sensor from the IP upper trim panel by twisting the sensor 1/4 turn counterclockwise.
  4. Remove the DRL ambient light sensor from the DRL ambient light sensor connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.