SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 830 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSSIDE WINDOW FILLER PANEL REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Side Window Filler Panel To Windshield Pillar
    GM423949Courtesy of GENERAL MOTORS CORP.
  1. Apply a continuous bead of sealant GM P/N 12345097, or equivalent, to the side window filler panel along the surface that will contact the windshield pillar as illustrated.
    2. Fig 2: Filler Panel To Windshield Pillar
    GM423947Courtesy of GENERAL MOTORS CORP.
  2. Position the filler panel to the windshield pillar.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws attaching the side window filler panel.

    Tighten:  Tighten the filler panel screws to 2.5 N.m (22 lb in).

  4. Wipe off any excessive sealant that squeezed out around the filler panel.
  5. Install the windshield side reveal molding, the side weatherstrip retainer, and the weatherstrip. Refer to Side Reveal Molding Replacement (Coupe and Convertible)  or Side Reveal Molding Replacement (Hardtop) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.