Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 80 (BODY CONTROL MODULES)SELF-DIAGNOSTIC SYSTEMTIRE PRESSURE MONITORING SYSTEM DIAGNOSTIC SYSTEM CHECK
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Tire Pressure Monitoring System Diagnostic System Check
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Tire Pressure Monitoring System Diagnostic System Check
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use this check as starting point for any tire pressure monitoring system complaint.
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. If scan tool powers up, go to next step. If scan tool does not power up, go to TEST D: SCAN TOOL DOES NOT POWER UP under SYSTEM TESTS.
- Turn ignition switch to RUN position. Try to establish scan tool communication with Electronic Brake Control Module (EBCM). If communication with EBCM is established, go to next step. If communication with EBCM is not established, go to TEST C: SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE under SYSTEM TESTS.
- Select DISPLAY DTC function for DRP/ABS/TCS/TIM/VSES (if equipped). If scan tool does not display any DRP/ABS/TCS/TIM/VSES DTCs, go to next step. If scan tool displays any DRP/ABS/TCS/TIM/VSES DTCs, go to ANTI-LOCK BRAKE SYSTEM DIAGNOSTIC SYSTEM CHECK .
- Using scan tool check for DTCs. If scan tool displays DTC C1245, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS . Repair as necessary. If scan tool does not display DTC C1245, system is okay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.