Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 80 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC B1339: DEVICE POWER NO. 3 CIRCUIT OPENCONDITIONS FOR SETTING THE DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Conditions For Setting The DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Conditions For Setting The DTC
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
The BCM must detect:
- The B+ supply circuit for load and RAP functions is less than 1 volt
- The B+ supply circuit for the lock and trunk release functions is less than 1 volt
- The above conditions last for more than 300 milliseconds
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.