Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Data Link Connector
The Data Link Connector (DLC) is a standardized 16-pin connector located below instrument panel, right of steering column. Both connector design and location are dictated by industry wide agreement to follow SAE J1962 standards.
All DLCs are required to provide a power supply, hot at all times, to Pin 16. This circuit is used to power scan tool. All DLCs provide a power ground at Pin 4 and a clean signal ground at Pin 5. Class 2 serial data communications circuit is provided at Pin 2 of DLC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.