Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the headlamp bulb/socket to the capsule.
  2. Install the headlamp bulb/socket retaining ring to the capsule, rotating clockwise until fully seated.
  3. Align and install the headlamp capsule to the headlamp mounting bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the headlamp capsule to headlamp mounting bracket bolts.

    Tighten 

    Tighten the headlamp capsule to headlamp mounting bracket bolts to 4 N.m (35 Ib. in).

  5. Install the headlamp assembly to the vehicle. Refer to HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT  .
  6. Check and adjust the headlamp aim as necessary. Refer to HEADLAMP AIMING  .
    Fig 1: Installing Headlamp Capsule To Headlamp Mounting Bracket Bolts
    G01503261Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.