SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 716 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER MOTOR REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper motor splash shield onto the wiper motor.
  2. Position the wiper motor to the wiper motor module.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the wiper motor screws.

    Tighten  Tighten the screws to 10 N.m (89 lb in).

  4. Install the wiper motor crank arm. Refer to WIPER MOTOR CRANK ARM REPLACEMENT  . 
  5. Install the wiper drive system module. Refer to WIPER DRIVE SYSTEM MODULE REPLACEMENT  . 
  6. Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
  7. Inspect the wipers for proper operation.
    Fig 1: Installing Wiper Motor Splash Shield Onto Wiper Motor
    G01453465Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.