SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 705 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE (BPMV) REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Removal Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the EBCM harness connector.
  3. Remove the BPMV pump motor ground wire.
  4. Remove the brake pipes from the master cylinder to the BPMV (1, 2), noting the location.
    Fig 1: Removing Brake Pipes From Master Cylinder To BPMV
    G01420465Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake pipes from the BPMV (1, 2) to the front brake calipers, noting the location.
    Fig 2: Removing Brake Pipes From Master Cylinder To Front Brake Calipers
    G01420466Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pipes from the BPMV (1, 2) to the rear brake calipers, noting the location.
    Fig 3: Removing Brake Pipes From BPMV To Rear Brake Calipers
    G01420467Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connector from the brake fluid pressure sensor (2).
  8. Remove the two insulator nuts (1).
  9. Remove the EBCM/BPMV from the vehicle as one unit.
    Fig 4: Removing EBCM/BPMV
    G01420468Courtesy of GENERAL MOTORS CORP.
  10. Remove the insulator mounting bolt from the EBCM.
  11. Remove the four EBCM to BPMV bolts.
  12. Separate the EBCM from the BPMV by gently pulling apart until separated.
  13. Carefully remove the seal.

    The seal may be reused if it is not cut or damaged.

Fig 5: Separating EBCM From BPMV
G01420469Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.