Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 641 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSREARVIEW MIRROR REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Removal Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the electrical connector (3) from the back of the mirror.
- Remove the wire harness cover.
- Adjust the mirror to the full upward position.
- Remove the base trim cover.
- Loosen the screw at the base in order to remove the mirror from the button.
- Slide the mirror in an upward motion in order to remove.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.