Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 637 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Installation Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The hood latch release cable must be connected to the hood latch support bracket.
- Install the hood latch release cable to the hood latch.
- Align the hood latch to the marks on the hood latch support bracket.NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the nuts to the hood latch.
Tighten: Tighten the hood latch nuts to 6 N.m (53 lb in).
- Adjust the hood, if required. Refer to Hood Adjustment .
- Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.