SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 621 (ENGINE CONTROLS - 3.6L (LY7) (INTRODUCTION))REPAIR INSTRUCTIONSFUEL TANK REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Removal Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Always maintain cleanliness when servicing fuel system components.
  1. Relieve the fuel system fuel pressure. Refer to Fuel Pressure Relief Procedure .
  2. Drain the fuel tank. Refer to Fuel Tank Draining Procedure .
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    4. Fig 1: Identifying Fuel Tank Wiring Harness Connector
    GM680801Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel tank wiring harness connector (1).
    5. Fig 2: View Of Fuel Evaporative Emission (EVAP) Pipes
    GM1404183Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel evaporative emission (EVAP) pipes. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 3: Identifying EVAP Canister Bracket Nut
    GM669530Courtesy of GENERAL MOTORS CORP.
  6. Remove the EVAP canister bracket nut.
    7. Fig 4: View Of Fuel Tank Fill Pipe Hose & Clamp
    GM670051Courtesy of GENERAL MOTORS CORP.
  7. Loosen the fuel tank fill pipe hose clamp.
  8. Disconnect the fuel tank fill pipe hose (2) from the fuel tank (1).
  9. Disconnect the EVAP vent pipe near the fill pipe hose. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    10. NOTE: Do not bend the fuel tank straps. Bending the fuel tank straps may damage the straps.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.