Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 617 (ANTILOCK BRAKE SYSTEM AND TRACTION CONTROL SYSTEM)REPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE (BPMV) REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Removal Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the OFF position.
- Remove the attaching bolts for the cruise control module, if equipped.
- Swing the cruise control module off to the side, if equipped.
- Remove the air cleaner housing from the engine compartment. Refer to Air Cleaner Assembly Replacement in Engine Controls.
- Disconnect the electronic brake control module (EBCM) harness connector (1).
- Disconnect the EBCM to brake pressure modulator valve (BPMV) connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.