Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 609 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENT (AZTEK)INSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Installation Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the high mounted stop lamp plastic retainer nuts to the roof panel pressing into place until fully seated.
- Connect the electrical connector to the high mounted stop lamp.
- Position the high mounted stop lamp retainer tabs to the slots in the roof panel.
Press the high mounted stop lamp in place until fully seated.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.