Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector.
  2. Install the radio front speaker.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the radio front speaker screws.

    Tighten 

    Tighten the radio front speaker screws to 1.9 N.m (17 lb in).

  4. Install the DRL sensor to the right speaker grille, if equipped.
  5. Turn the DRL sensor counterclockwise 1/4 turn in order to install.
  6. Install the radio front speaker grille.
    Fig 1: Front Speaker Grille Screws
    G01476509Courtesy of GENERAL MOTORS CORP.
  7. Install the radio front speaker grille screws.

    Tighten 

    Tighten the radio front speaker screws to 1.9 N.m (17 lb in).

  8. Inspect for proper circuit operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.