SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 587 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSREMOTE CD PLAYER REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the electrical connector to the CD changer.
  2. Install the CD changer assembly into the center console.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the front CD changer assembly retaining screws (1).

    Tighten 

    Tighten the front CD changer assembly retaining screws to 1.9 N.m (17 lb ft).

  4. Install the rear CD changer assembly retaining screw.

    Tighten 

    Tighten the rear CD changer assembly retaining screw to 2.5 N.m (22 lb ft).

  5. Close the center armrest.
    Fig 1: Remote CD Player
    G01476499Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.