SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 585 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSINSTRUMENT PANEL (I/P) LAMP REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulbs into the cluster by inserting the bulb and base assembly, and turning the bulb turn clockwise.
    Fig 1: Installing Bulb & Base Assembly By Turning 1/2 Turn Clockwise
    G01476292Courtesy of GENERAL MOTORS CORP.
  2. Carefully snap the rear cover plate to the IPC.
  3. Install the IPC. Refer to INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT in Instrument Panel, Gages and Console.
  4. Connect the negative battery cable.
    Fig 2: Installing Rear Cover Plate To Instrument Panel Cluster
    G01476293Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.