Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (COMPUTER RELEARN PROCEDURES)GENERAL MOTORS (CARS)DEVILLE, ELDORADO & SEVILLEELECTRONICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) PROGRAMMING
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
- If Powertrain Control Module (PCM) was replaced, the EEPROM in the PCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM or PCM may be damaged. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model. Perform Vehicle Theft Deterrent (VTD) system auto learn procedure. See VEHICLE THEFT DETERRENT SYSTEM AUTO LEARN PROCEDURE . Perform idle air control and throttle position sensor relearn procedures. See IDLE AIR CONTROL VALVE RELEARN PROCEDURE and THROTTLE POSITION SENSOR RELEARN PROCEDURE .
- To verify proper EEPROM programming, start engine. If engine starts, go to next step. If engine fails to start, ensure all electrical connections on PCM are okay and all fuses are okay. Check Techline for latest software. Once engine is repaired so it will start, go to next step.
- Once EEPROM is programmed, use scan tool to clear DTC P0603 from PCM. Engine oil life interval and transaxle fluid life interval must now be reprogrammed. See ENGINE OIL LIFE INTERVAL PROGRAMMING . See TRANSAXLE FLUID LIFE INTERVAL PROGRAMMING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.