SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 542 (SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Removal Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
  3. Remove the fasteners.
    Fig 1: Removing Fasteners From Seat Cushion Assembly
    G01518114Courtesy of GENERAL MOTORS CORP.
  4. Adjust the front seat assembly to the rear of the vehicle.
  5. Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
  6. Remove the fasteners.
  7. Lift the front seat cushion assembly (1) away from the seat riser.
    Fig 2: Lifting Front Seat Cushion Assembly Away From Seat Riser
    G01518115Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical connector.
  9. Using a flat-bladed tool, release the module from the bracket.
  10. Remove the memory seat module from the seat frame.
    Fig 3: Removing Memory Seat Module From Seat Frame
    G01518116Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.