SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 501 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSREMOTE CD PLAYER REPLACEMENTINSTALLATION PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Installation Procedure

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the CD player into the mounting bracket.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the fasteners in order to secure the CD player to the bracket.

    Tighten 

    Tighten the fasteners to 2 N.m (18 lb in).

    Fig 1: Installing CD Player To Bracket
    G01801106Courtesy of GENERAL MOTORS CORP.
  3. Position the CD player and bracket into the rear compartment.
  4. Connect the electrical connectors.
  5. Install the fasteners in order to secure the rear compartment CD player and bracket to the vehicle.

    Tighten 

    Tighten the rear compartment CD player bracket fasteners to 9 N.m (80 lb in).

    6. Fig 2: Installing CD Mounting Bracket
    G01801107Courtesy of GENERAL MOTORS CORP.
  6. Install the rear compartment trim. Refer to COMPARTMENT TRIM PANEL REPLACEMENT--REAR .
  7. Close the rear compartment deck lid.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.