Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 469 (WHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURES)REPAIR INSTRUCTIONSREAR TOE ADJUSTMENT
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Rear Toe Adjustment
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Rear Toe Adjustment
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Important: Complete the left and right rear toe adjustments separately, per wheel. Use the following procedure.
- Loosen the inner adjustment link cam nut.CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- In order to adjust the toe, rotate the cam bolt. Refer to Fastener Tightening Specifications
.
Tighten
Tighten the cam nut (2) to 91 N.m (67 ft lbs).
- Recheck the toe setting after tightening.
- Readjust the toe setting if necessary. Refer to Wheel Alignment Specifications .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.