Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 457 (ENTERTAINMENT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESRADIO POOR RECEPTIONANTENNA SYSTEM TEST
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Antenna System Test
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Antenna System Test
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Important:Β Always zero out the DMM before taking a resistance measurement in order to ensure an accurate reading.
- Disconnect the negative battery cable.
- Disconnect the antenna lead-in connector from the radio receiver.
- Measure the resistance from the negative battery cable to the coax, outer conductor connector.
- The resistance measured should be 0.20 Ξ© or less.
- Test the following when the resistance is greater than 0.20 Ξ©.
- Base of the antenna for a poor connection to body ground.
- The coaxial cable interconnects for a poor connection or corrosion.
- Test for an open or high resistance from the battery negative cable to the body. Refer to CIRCUIT TESTING and WIRING REPAIRS .
- After finding and correcting the condition, operate the system in order to verify the repair.
Perform the Antenna Checking Procedures after confirming the integrity of the antenna ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.