Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 301 (ENGINE CONTROLS SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0325: KNOCK SENSOR MODULE CIRCUITCONDITIONS FOR RUNNING DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Conditions For Running DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0101, P0102, P0103, P0116, P0117, P0118, P0121, P0122, P0123, P0125, P0336, P0341, P0502, P0503, P1114, P1115, P1121, P1122, or P1336 not set.
- Engine speed is 1000-5000 RPM.
- Throttle angle is more than 15 percent.
- Engine load is more than 45 percent.
- ECT is more than 140°F (60°C).
- Maximum spark retard is less than 15 degrees.
- System voltage is more than 9 volts.
- Engine run time is more than 30 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.