SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 237 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSENGINE COMPARTMENT FUEL HOSESREMOVAL (2.2L)
1998 Chevrolet Suburban K2500, 7.4 J, Part Time

Removal (2.2L)

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Removal (2.2L)
WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The numbers in parenthesis corresponds to numbered components in referenced illustrations.
  1. Relieve the fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE  .
  2. Remove the air cleaner outlet duct.
  3. Disconnect the battery cables and remove the battery.
  4. Remove the relay center push in retainer.
  5. Disconnect the relay battery feed cable from the upper air cleaner cover retaining clips.
  6. Position the relay center away from the air cleaner assembly.
  7. Remove the push in retainer from air cleaner assembly to the battery tray.
  8. Remove the air cleaner assembly. See Fig 1 .
  9. Disconnect the fuel flex hoses (1, 5) from the chassis fuel pipes (2, 4). See FUEL LINE QUICK CONNECT FITTINGS  .
  10. Disconnect the fuel flex hoses (1, 5) from the engine fuel pipes. See FUEL LINE QUICK CONNECT FITTINGS  .
  11. Remove the fuel flex hoses. See Fig 2 .
Fig 1: Removing/Installing Air Cleaner Assembly (2.2L)
G00217367Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.