Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 173 (ENGINE CONTROL SYSTEM TESTING & ENGINE COMPONENT TESTING)EMISSION SYSTEMS & SUBSYSTEMSEVAPORATIVE EMISSION SYSTEM CLEANINGCLEANING PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Cleaning Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Cleaning Procedure
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, 2002 Saturn SC2, and 2002 Saturn SC1. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle.
- Remove the EVAP canister.
- Turn OFF the main valve on the J 41413.
- Disconnect the hose from the diagnostic station pressure regulator.
- Using a section of vacuum hose, connect one end onto the diagnostic station pressure regulator.
- Connect the other end of the vacuum hose to the canister side of the purge pipe.
- Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
- If the nitrogen does not dislodge the carbon particles, replace the purge pipe.
- Return the EVAP pressure/purge diagnostic station to the original condition of the station.
- Install a new EVAP canister.
- Lower the vehicle.
- Install a new EVAP canister purge valve.
- Return to the published service procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.