Component Locations (5.7L VIN G - Corvette)

1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Component Locations (5.7L VIN G - Corvette)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, 2002 Saturn SC2, and 2002 Saturn SC1. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS (5.7L VIN G - CORVETTE)

Component Location
A/C Refrigerant Pressure Sensor Attached To A/C High Side Line
Body Control Module Mounted On Toe Board
Cooling Fan Relays In Right Side Of Engine Compartment, In Underhood Electrical Center
Data Link Connector Under Left Side Of Instrument Panel
Engine Coolant Temperature Sensor Left Side Of Engine, Below Generator
Engine Oil Level Switch Right Side Of Oil Pan
Engine Oil Pressure Sensor Top Center, Rear Of Engine
EVAP Canister Purge Solenoid At Left Side Of Engine, On Intake Manifold
EVAP Canister Vent Solenoid Right Side Rear Compartment Brace, Inside Rear wheelwell Panel
Fuel Injectors In Intake Manifold
Ignition Control Modules On Valve Cover At Top Of Each Cylinder
Intake Air Temperature Sensor Part Of MAF Sensor
Knock Sensors Center Of Engine, Below Intake Manifold
Manifold Absolute Pressure Sensor Rear Of Intake Manifold
Mass Airflow Sensor In Intake Duct Before Air Filter Assembly
Post-Converter Oxygen Sensors Rear Of Catalytic Converters
Powertrain Control Module On Right Side Of Engine Compartment, Rear Of Wheelwell
Pre-Converter Oxygen Sensors Rear Of Engine, In Exhaust Manifolds
Throttle Actuator Control Module Mounted On Side Of Powertrain Control Module, Below Battery
Throttle Actuator Motor Left Side Of Throttle Body
Throttle Position Sensor On Throttle Body
Transaxle Range Switch Left Side Of Transmission
Underhood Electrical Center Right Side Of Engine Compartment, Between Wheelwell & Instrument Panel
Vehicle Speed Sensor At Top Right Of Differential
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.