Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 143 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.1L ENGINE)DIAGNOSTIC TESTSDTC P0325: KNOCK SENSOR MODULE CIRCUITACTION TAKEN WHEN DTC SETS
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Action Taken When DTC Sets
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Action Taken When DTC Sets
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Malibu, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- The control module illuminates the Malfunction Indicator Light (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.