Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 143 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.1L ENGINE)DIAGNOSTIC TESTSDTC P0101: MAF SENSOR PERFORMANCECONDITIONS FOR RUNNING DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Conditions For Running DTC
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Malibu, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0102, P0103, P0107, P0108, P0121, P0122, P0123, P0401, P0404, P0405, P0440, P0442, P0446, P1404, and P1441 are not set.
- The engine is running.
- The ignition 1 signal is 9-18 volts.
- The TP sensor angle is less than 25 percent.
- The change in the TP sensor angle is less than 1.5 percent.
- The MAP sensor is less than 63 kPa.
- The change in the MAP sensor is less than 3 kPa.
- The above conditions are met for 5 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.