Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998SUBURBAN K2500, 7.4 J, PART TIMEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 101 (COMPUTER RELEARN PROCEDURES)COMPUTER RELEARN PROCEDURES - TRUCKS & VANSASTRO & SAFARICRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE
1998 Chevrolet Suburban K2500, 7.4 J, Part Time
Crankshaft Position (CKP) Sensor Variation Learn Procedure
1998 Chevrolet Suburban K2500, 7.4 J, Part TimeSECTION Crankshaft Position (CKP) Sensor Variation Learn Procedure
WARNING: This page does not describe the selected car, but rather 69 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
- Procedure must be performed if any of the following have been done:
- EEPROM was reprogrammed.
- If crankshaft position sensor was removed or replaced.
- Vehicle Control Module (VCM) was replaced.
- Install scan tool on Data Link Connector (DLC). Apply parking brake. Block rear wheels. Ensure hood is closed.
- Place transmission in Park (A/T models) or Neutral (M/T models). Start engine and warm engine until engine coolant temperature is at least 150°F (65°C). Ensure all accessories are off.
- Apply service brakes. With engine idling, use scan tool to select and enable CKP sensor variation learn procedure.
- Gradually accelerate engine to 4000 RPM. Quickly release throttle to idle position once CKP sensor variation learn procedure is obtained and engine starts to decelerate. Once CKP sensor variation values are learned, the VCM will return engine control to the operator and engine will respond to throttle position.CAUTION: Ensure throttle is quickly released to idle position once CKP sensor variation learn procedure fuel cut off is obtained and engine starts to decelerate.
- If CKP sensor variation learn procedure was completed, turn ignition off for at least 15 seconds and remove scan tool. If CKP sensor variation learn procedure was not completed, a DTC P1336 should be stored in the VCM. Perform test procedures for DTC P1336 and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.