SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998S10 PICKUP 2D PICKUP, 2.2 4, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESPECIFICATIONSENGINE CONTROLS - SERVICE & ADJUSTMENT SYSTEM SPECIFICATIONS - 2.2LCAPACITIES
1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, Automatic

Engine Controls - Service & Adjustment System Specifications - 2.2L: Capacities

1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, AutomaticSECTION Capacities
BATTERY SPECIFICATIONS

Series Cold Crank Amps @ 0°F (-18°C) Reserve Capacity (Minutes)
S/T 525 90
" 690 90
FLUID CAPACITY (CRANKCASE) (1)

Application (2) Quantity Qts. (L)
2.2L 4.5 (4.3)
(1) Fluid capacities listed are approximate. Always fill to FULL mark.
(2) Includes oil filter capacity.
FLUID CAPACITY (COOLING SYSTEM) (1)

Application (2) Quantity Qts. (L)
2.2L 11.6 (11.0)
(1) Fluid capacities listed are approximate. Always fill to FULL mark.
(2) Includes heater.
FLUID CAPACITY (AUTOMATIC TRANSMISSION) (1)

Application (2) Quantity Qts. (L)
2.2L (4L60-E) 5.0 (4.7)
(1) Fluid capacities listed are approximate. Always fill to FULL mark with Dexron-III.
(2) Drain and refill capacity only. Does not include torque converter, unless specified otherwise.
FLUID CAPACITY (MANUAL TRANSMISSION) (1)

Application Quantity Qts. (L)
2.2L (2) 2.9 (2.7)
(1) Fluid capacities listed are approximate. Always fill to FULL mark.
(2) Synchromesh Transmission Fluid (GM 12345349).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.