Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998S10 PICKUP 2D PICKUP, 2.2 4, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULETBC/BCM RELEARN PROCEDURENOTES
1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, Automatic
TBC/BCM Relearn Procedure: Notes
1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, AutomaticSECTION Notes
NOTE:
A scan tool can be used to perform relearn procedure. Refer to scan tool manufacturer's instructions. Procedure will take about 10 minutes with use of scan tool.
Relearn procedure should be performed if any of the following components are replaced, PassLock(R) sensor, TBC Module, PCM or VCM. Performing relearn procedure without the use of a scan tool will take about 30 minutes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.