Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1998S10 PICKUP 2D PICKUP, 2.2 4, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULETBC MODULE PROGRAMMING/RPO CONFIGURATIONBODY CONTROL MODULEPROGRAMMING PROCEDURE
1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, Automatic
Programming Procedure
1998 Chevrolet S10 Pickup 2D Pickup, 2.2 4, AutomaticSECTION Programming Procedure
- Ensure battery is fully charged. Turn ignition switch to RUN position. Program TBC module using scan tool. Refer to Techline(R) terminal and equipment user's instructions.
- If TBC module fails to program, check all connections. Ensure latest software version for scan tool is used. Retry programming TBC module. If programming fails again, replace TBC module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.