Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997VENTURE BASE, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEMSYSTEM CUSTOMIZATIONAUTOMATIC DOOR LOCK OPERATION MODESNOTES
1997 Chevrolet Venture Base, Van Passenger Extended
Automatic Door Lock Operation Modes: Notes
1997 Chevrolet Venture Base, Van Passenger ExtendedSECTION Notes
- Remove BCM PRGRM fuse located in instrument panel fuse block. Turn ignition to ACCESSORY position. Seat belt warning light flashes and chime sounds 2-4 times to indicate vehicle is in customization mode.
- When either door lock switch is pressed to LOCK position, the seat belt warning light will flash and chime will sound to indicate current customization mode. When Mode 4 is reached, Mode 1 will be repeated. To exit and save current customization mode, turn ignition off. Replace BCM PRGRM fuse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.